4 Degree x 2.5" Wide Shim, (DM5904) DAN706527X-HD Thread lengths (approximate): short end

Thread lengths (approximate):  short end = 0

Using these clips instead of the C-clips that come with the u-joint reduce the likelihood of the cap spitting out when the ear of the axle shaft augers out

is important for high lifts (this is the part that would bolt to the Parts Mike Flange)

A six stud GM spindle fits perfectly

WARNING: This item will only work on Jeep CJs with existing factory disc brakes where the caliper bracket bolts to the knuckle with two bolts

4 Degree x 2.5" Wide Shim, (DM5904) DAN706527X-HD Thread lengths (approximate): short endYou've selected the 4 degree axle shim These shims are sold individually! You'll need two for a rear axle, or three (yes 3) for a Dodge or Chevy Dana 60 front axle. These axles require one on each side of the leaf spring for the perch housing because there's two studs instead of a U bolt. The shim on the other side goes the opposite direction, keeps the studs perpendicular to the spring plate, and allows the nuts and washers to sit flat. A rear axle